Jackson Fan Oven Elements, Jackson Grill Elements, Jackson Cooker Elements
Jackson Oven and Grill Elements (Total Products 8, Showing: 1 -> 4)
Genuine Spare Part
Base Element 1200 watts
Base Oven Element to fit Jackson Cookers
Length 375 mm
Width 320 mm
Bracket 30 mm
Part No C00233808 was 6224630
Jackson Cooker models to fit
28101
28102
28103
28104 ...
Fits Hotpoint, Creda, Cannon, Indesit, and Jackson.This is half width at 165mm with a lenth of 370mm and a fixing braket 65mm wide Grill Element which will fit either side and which can be replaced without changing the other half and will restore your cooker grill to back to full working order
Manufactures Part No for reference is C00233740 was...
Genuine Spare Part
Jackson Grill Element
Element for Grill to fit Jackson Cookers
2600 watts
Part No C00224344 was 6101412
Jackson Cooker models to fit
28241, 28243, J011EW,
J131EW, J121EW, J160EW,
Genuine Spare Part
Jackson Grill Element
Element for Grill to fit Jackson Cookers
1750 watts
Length 290 mm
Width 320 mm
Bracket 65 mm
Tags: 40 mm
Part No C00226997 was 6201301
Jackson Cooker models to fit
49140
49140
...
Jackson Oven Elements and Jackson Grill Elements
Jackson Fan Ovens - Built-In or Free Standing Jackson Cookers
The heating element which produces the heat to maintain a cooking temperature in an oven is installed in the rear of a oven box in a circular form around the oven fan blade which distributes the hot air round the oven to produce an even cooking temperature over the whole of the oven with cooking times being reduced in a fan oven
All Jackson oven fan motors should turn all the while the oven is turned on, failure of the oven fan to turn at full speed will result in poor cooking results and can cause the element to fail
Power to the oven elements is controlled either mechanically by turning a temperture dial or thermostat contol or electronically by a timer control panel.When an oven fails to come on you should always first check the auto clock to ensure this is set correctly, needs to be on a manual setting for the oven to come on
Oven fan elements have a fairly high rate of failure and will often cause the electrical supply to trip or to blow a fuse, failure is also sometimes accompanied by a covering of white powder substance over the oven caused by a split in the metal covering of the element
Most elements are fitted from inside the oven compartment and can reached by removing the covering plate from back of the compartment, however some elements are retained to the rear of the oven by threaded studs from the element bracket and retained by nuts which means the element is only removable by access to the rear of the oven box
Ensure that when replacing an Jackson Oven Element that the fixings for the element are secure and tight, failure to secure the element can result in this touching the fan blade which make the oven very noisy but also can damage the element which can shorten its life, be also very careful if spraying the oven with an oven cleaner to make sure that this does not come into contact with the element, this will again damage the element surface which will reduce its life
Jackson Ovens - Built-In or Free Standing with conventional heating elements and Fan heating elements
These ovens use a base element which is fitted under bottom of the main oven box together with the outer ring of the the grill element to provide heat for conventional heating ovens,
Jackson oven base elements can only be accessed from the rear of the oven but the grill may in some cases be able to be changed from inside the the oven box by removal of screws from the fixing bracket, be aware that when extracting the element it will have connecting wires attached, other may have stud fixing which again will have to removed from the rear of the cooker.
Changing a Jackson element should only be undertaken by a qualified or competent person with the electric supply disconnected